Kenco-engineering KUSG Switch User Manual download pdf

KENCO ENGINEERING COMPANY

P.O. BOX 470426 TULSA, OK 74147-0426 ● PHONE: (918) 663-4406 FAX: (918) 663-4406

www.kenco-eng.com e-mail: [email protected]

MODEL KUSG ULTRASONIC SWITCH

INSTALLATION / OPERATION INSTRUCTIONS

GENERAL DESCRIPTION

The KUSG Series Ultrasonic Level Switches are ideal, low cost solutions for many liquid level control applications. They

operate in a wide variety of services.

PRINCIPLE OF OPERATION

Ultrasonic switches use piezoelectric crystals to transform electrical energy into mechanical motion (sound). The

Transmit Crystal sends a pulse of sound through the space between the crystals, to the Receive Crystal. If the space is

filled with air, gas, or vacuum, the Receive Crystal does not detect the sound pulse. However, if the space is filled with

liquid, any liquid, the pulse is detected by the Receive Crystal, and the switch output changes.

MODEL DESCRIPTION

KUSG - - - - - - - -

Input Power

Output

Switch Mounting

Sensor Material

Sensor Length

Process Connection

Flange Size

Flange Material

INSTALLATION

Unpack the switch carefully. Inspect all units for damage. Report any damage to carrier immediately. Check the

contents against the packing slip and purchase order.

Kenco’s Ultrasonic Switches are manufactured to the highest quality standards. These switches use electronic

components that can be damaged by static electricity. Make sure that you are properly grounded before starting

installation. Insure that all electrical connections are properly made, and that there are no “floating” connections.

Sensor Material

Sensor Length

Flange Size

Flange Material

Description Code Description Code Description Code Description Code

316LSS S Standard (1”) 00 None None

Monel

M Inches (2” – 120”)

xxx 1-1/2” 0 Carbon Steel A

Hastelloy B

HB 1 1 316SS S

Hastelloy C

HC 2 2 Hastelloy C

Teflon

T 3 3 CPVC C

Kynar

K Kynar

CPVC C Teflon

Input Power

Output

Description Code Description Code

115Vac 1 10A DPDT 1

230Vac 2

24Vdc 3

Process Connection

12Vdc 4 Description Code

¾” NPT 1

Switch Mounting

150# Flange F

Description Code 300# Flange H

Integral 1 Sanitary Flange S

*Remote 2

*Remote 10ft. (std.)

100ft. (max)

1 2 3 4

Summary of Contents

Page 1 - KENCO ENGINEERING COMPANY

KENCO ENGINEERING COMPANY P.O. BOX 470426 TULSA, OK 74147-0426 ● PHONE: (918) 663-4406 FAX: (918) 663-4406 www.kenco-eng.com e-mail: info@kenco-eng.

Page 2

Operational Check Before installing the switch a simple operational check should be performed, as follows: 1. Fill a container with water 2. Open t

Page 3 - + GL2L1NCCNONCCNO

Wiring It is recommended that conduit be installed onto the ¾” NPT connection on the electronics housing. A seal drain fitting should be used to prev

Page 4

Specifications Description Specification AC 115Vac or 230Vac; 50/60Hz Input Power DC 12 or 24Vdc Output 10A DPDT Switch -20°F to 170°F Temperatu

Comments to this Manuals

No comments

Kenco-engineering KUSG Switch User Manual

Browse online or download User Manual for Sensors Kenco-engineering KUSG Switch. Kenco Engineering KUSG Switch User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Sensors Kenco-engineering KUSG Switch