Kenco-engineering KMD Transmitter User Manual

Page 1 KENCO ENGINEERING COMPANY P.O. BOX 470426 TULSA, OK 74147-0426 ● PHONE: (918) 663-4406 FAX: (918) 663-4480 www.kenco-eng.com e-mail: info@ken

Page 10 Operation Modes Run Mode -- This is the primary mode of operation. It performs measurements, displays data, and responds to HART commands.

Page 11 Menu Structure Setup Using HART® Handheld Communicator HART is an acronym for "Highway Addressable Remote Transdu

Page 12 Setup Using PC Setup Software The transmitter can also be calibrated using a HART Modem and a PC

Page 13 Installing the Software 1. Insert the CD into the proper drive. 2. If you don’t have the CD, contact Kenco, and have a copy of the softw

Page 14 Advanced Click the Advanced Setup Tab. Confirm that the Gradient, Length, and Head Adder have been received fr

Page 15 Calibration The Calibration Tab is used to set the Zero (LRV) and Span (URV) points for the Level Float (Level

Page 16 Output The Output Tab shows you the present output values for the transmitter. To update the values, click th

Page 17 Specifications Description Specification Power Supply 10.5 – 36.1Vdc; 24Vdc nominal Temperature Range (Electronics) -30°F to 160°F (-34°C to

Page 2 GENERAL DESCRIPTION The KMD Series Magnetostrictive Liquid Level Transmitters are designed for very high accuracy measurement of virtually any

Page 3 INSTALLATION Unpack the switch carefully. Inspect all units for damage. Report any damage to carrier immediately. Check the contents against

Page 4 For threaded process connections, screw sensor into the opening using a wrench on the NPT Fitting (bottom half for swaged

Page 5 Complete the following steps to mount the sensor using the welded flange method: 1. Remove the Retaining Hardware. Install the float(s) on

Page 6 Installation Drawing – Series KMD Transmitter

Page 7 Product Dimensions 5 in. (127mm) 8.25 in. (210mm) 8.25 in. (210mm) 4.84 in. (123mm) 5 i

Page 8 Conduit Installation Wiring Connections Before starting installation procedures in hazardous areas, insure that all power

Page 9 4. Pull the power/signal wires through the conduit opening. 5. Connect the (+) and (-) wires to the plug. In the photo, the (+) connec